12262
1.DISCONNECT NO. 2 VENTILATION HOSE
17880
2.REMOVE AIR CLEANER HOSE ASSEMBLY
3.REMOVE AIR CLEANER CAP SUB-ASSEMBLY
17801
4.REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
17701
5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
6.REMOVE BATTERY
74431
7.REMOVE BATTERY TRAY
74410
8.REMOVE BATTERY CARRIER ASSEMBLY
58910C
9.REMOVE REAR CONSOLE BOX ASSEMBLY
58816D
10.REMOVE NO. 1 FRONT CONSOLE BOX INSERT
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL
58817A
11.REMOVE NO. 2 FRONT CONSOLE BOX INSERT
58911A
12.REMOVE NO. 1 SIDE BOX PANEL
58912C
13.REMOVE NO. 2 SIDE BOX PANEL
58916
14.REMOVE BOX BOTTOM MAT
58839A
15.REMOVE CONSOLE BOX HOLE COVER
58810J
16.REMOVE CONSOLE BOX ASSEMBLY
57533B
17.REMOVE FRONT FLOOR CENTER BRACE
17410
18.REMOVE FRONT EXHAUST PIPE ASSEMBLY
58151
19.REMOVE FRONT NO. 1 FLOOR HEAT INSULATOR
Remove the 2 bolts, nut and front No. 1 floor heat insulator from the body.
33820B
20.REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY
| *1 | Clip A |
| *2 | Clip B |
| *3 | Nut |
|
Rotate approximately 180° |
Remove the clip A to disconnect the select cable end of the transmission control cable assembly from the floor shift shift lever assembly.
Widen the clip B to disconnect the shift cable end of the transmission control cable assembly from the floor shift shift lever assembly.
Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the floor shift shift lever assembly.
Do not rotate the nut excessively as it may damage the internal spring and transmission control cable assembly will not be reusable.
Remove the 2 clips A and 2 washers to disconnect the transmission control cable assembly from the manual transaxle assembly.
Remove the 2 clips B to separate the transmission control cable assembly from the No. 1 transmission control cable bracket.
Remove the 3 nuts and transmission control cable assembly from the body.