58910C
1.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)
58910C
2.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)
58816D
3.REMOVE NO. 1 FRONT CONSOLE BOX INSERT (for TMT Made)
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>REMOVAL
58817A
4.REMOVE NO. 2 FRONT CONSOLE BOX INSERT (for TMT Made)
58911A
5.REMOVE NO. 1 SIDE BOX PANEL (for TMT Made)
58912C
6.REMOVE NO. 2 SIDE BOX PANEL (for TMT Made)
58916
7.REMOVE BOX BOTTOM MAT (for TMT Made)
58839A
8.REMOVE CONSOLE BOX HOLE COVER (for TMT Made)
58810J
9.REMOVE CONSOLE BOX ASSEMBLY (for TMT Made)
33820B
10.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
| *1 | Clip A |
| *2 | Clip B |
| *3 | Nut |
|
Rotate approximately 180° |
Remove the clip A to disconnect the select cable end of the transmission control cable assembly from the floor shift shift lever assembly.
Widen the clip B to disconnect the shift cable end of the transmission control cable assembly from the floor shift shift lever assembly.
Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the floor shift shift lever assembly.
Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.
33530F
11.REMOVE FLOOR SHIFT SHIFT LEVER ASSEMBLY
Disengage the 2 clamps to separate the wire harness from the floor shift shift lever assembly.
Remove the 4 bolts and floor shift shift lever assembly from the body.