Home › Drivetrain › K411 CVT › SHIFT LEVER(for TMT Made) › 2017.10–2018.01
RM30M0E _52 Drivetrain _052750 K411 CVT _0333891 SHIFT LEVER(for TMT Made) A

K411 CVT  SHIFT LEVER(for TMT Made)  REMOVAL  


PROCEDURE

Hide 58817A 3.REMOVE NO. 2 FRONT CONSOLE BOX INSERT

Hide 58911A 4.REMOVE NO. 1 BOX SIDE PANEL

Hide 58912C 5.REMOVE NO. 2 BOX SIDE PANEL

Hide 58839A 7.REMOVE CONSOLE BOX HOLE COVER

Hide 58810J 8.REMOVE CONSOLE BOX ASSEMBLY

Hide 33820B 9.DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

a.

Apply the parking brake and move the shift lever to N.


b.
C381177

Disconnect the end of the transmission control cable assembly from the transmission floor shift assembly.


c.
C381178C02
0.583,1.406 1.073,0.885 true 0.448,1.427 0.76,1.625 0.313,0.198 10 true *1
*1 Nut
V100135

Rotate approximately 180°
V100136

Pull out


Rotate the nut of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, separate the transmission control cable assembly from the transmission floor shift assembly.

NOTICE:

Rotating the nut too much will damage the internal spring, and the transmission control cable assembly will not be reusable. Do not turn the nut too far.



Hide 33550 10.REMOVE TRANSMISSION FLOOR SHIFT ASSEMBLY

a.

for LHD:

i.
C381179

Disconnect the 2 connectors from the transmission floor shift assembly.


ii.

Disengage the 4 clamps to separate the wire harness from the transmission floor shift assembly.



b.

for RHD:

i.
C375357

Disconnect the 2 connectors from the transmission floor shift assembly.


ii.

Disengage the 3 clamps to separate the wire harness from the transmission floor shift assembly.



c.
C381180

Remove the 4 bolts and transmission floor shift assembly from the body.