Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ANTI-LOCK BRAKE SYSTEM › from 2017.10
RM30M0E _54 Brake _017098 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0090184 ANTI-LOCK BRAKE SYSTEM D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ANTI-LOCK BRAKE SYSTEM  DIAGNOSIS SYSTEM  


DESCRIPTION


When troubleshooting a vehicle with the diagnosis system, the only difference from the usual troubleshooting procedure is connecting the GTS to the vehicle and reading various data output from the vehicle's skid control ECU (brake actuator assembly).

The skid control ECU (brake actuator assembly) records DTCs when the ECU detects a malfunction in the ECU itself or in its circuits.

To check the DTCs, connect the GTS to the DLC3 on the vehicle. The GTS enables you to clear the DTCs, activate the various actuators, and check the Freeze Frame Data and Data List.

a.

Check the battery voltage.

Standard voltage:

11 to 14 V


If the voltage is below 11 V, recharge the battery before proceeding to the next step.




DIAGNOSIS


a.

If the skid control ECU (brake actuator assembly) detects a malfunction, the ABS warning, brake warning will come on in order to warn the driver.


b.

DTCs are simultaneously stored in memory.

The DTCs can be read by connecting the GTS.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>DTC CHECK / CLEAR


c.

This system has a Test Mode (signal check) function.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ANTI-LOCK BRAKE SYSTEM>TEST MODE PROCEDURE



WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK


a.

Release the parking brake.

NOTICE:

Before releasing the parking brake, move the shift lever to P for safety (for Continuously Variable Transaxle) or use wheel chocks to secure the vehicle (for Manual Transaxle).


HINT:

When the parking brake is applied or the level of the brake fluid is low, the brake warning light comes on.



b.

When the ignition switch is turned to ON, check that the ABS warning and brake warning lights come on for approximately 3 seconds.

HINT:
·

If the warning light check result is not normal, proceed to troubleshooting for the ABS warning and brake warning light circuits.

If a light remains on or does not come on, proceed to troubleshooting for the light circuits listed below.



Trouble Area See Procedure
ABS warning light circuit (Remains on) (Click here)
ABS warning light circuit (Does not come on) (Click here)
Brake warning light circuit (Remains on) (Click here)
Brake warning light circuit (Does not come on) (Click here)