The skid control ECU (brake actuator assembly) outputs this DTC when it receives an internal malfunction signal from the steering angle sensor.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| C1433 | Steering Angle Sensor Internal Circuit | With the IG1 terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor. | ·
Steering angle sensor (Spiral cable sub-assembly)*1 ·
Steering angle sensor*2 |
*1: for TMMIN Made
*2: for TMT Made
Refer to DTC C1432.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>C1432
When U0073, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>VEHICLE STABILITY CONTROL SYSTEM>U0073
When the speed sensor or the yaw rate and acceleration sensor (airbag ECU assembly) has trouble, DTCs for the steering angle sensor (spiral cable sub-assembly)*1 or steering angle sensor*2 may be output even when the steering angle sensor is normal. When DTCs for the speed sensor or yaw rate and acceleration sensor (airbag ECU assembly) are output together with DTCs for the steering angle sensor (spiral cable sub-assembly)*1 or steering angle sensor*2, inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag ECU assembly) first, and then inspect and repair the steering angle sensor (spiral cable sub-assembly)*1 or steering angle sensor*2.
*1: for TMMIN Made
*2: for TMT Made
| Result | Proceed to |
|---|---|
| for TMMIN Made | A |
| for TMT Made | B |
A
B
Replace the spiral cable sub-assembly.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>SPIRAL CABLE(for TMMIN Made)>REMOVAL
Do not remove the steering angle sensor from the spiral cable sub-assembly.
When replacing the spiral cable sub-assembly, confirm that the replacement part is of the correct specification.
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.
| Proceed to |
|---|
| NEXT |
NEXT
Replace the steering angle sensor.
Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>STEERING ANGLE SENSOR>REMOVAL
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.
| Proceed to |
|---|
| NEXT |
NEXT