Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › SPIRAL CABLE(for TMMIN Made) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017115 SUPPLEMENTAL RESTRAINT SYSTEMS _0334260 SPIRAL CABLE(for TMMIN Made) A

SUPPLEMENTAL RESTRAINT SYSTEMS  SPIRAL CABLE(for TMMIN Made)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1. TURN FRONT WHEELS TO FACE STRAIGHT AHEAD

Hide 2. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 3.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 45100 4.REMOVE STEERING WHEEL ASSEMBLY

Hide 45287 5.REMOVE LOWER STEERING COLUMN COVER

Hide 45286B 6.REMOVE UPPER STEERING COLUMN COVER

Hide 84306 7.REMOVE SPIRAL CABLE SUB-ASSEMBLY

a.

Check that the ignition switch is off.


b.

Check that the cable is disconnected from the negative (-) battery terminal.


c.

Check that the front wheels are facing straight ahead.


d.
B349480C01
0.729,2.625 0.958,2.438 true 0.99,2.323 1.302,2.521 0.313,0.198 10 false *1
*1 Slider


Slide the slider to release the lock, and then disconnect the yellow airbag connector from the spiral cable sub-assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.



e.

Disconnect the connectors from the spiral cable sub-assembly.


f.
B346977

Disengage the 3 claws to remove the spiral cable sub-assembly.