Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT PASSENGER AIRBAG ASSEMBLY(for TMT Made) › 2017.10–2018.01
RM30M0E _58 Vehicle Interior _017115 SUPPLEMENTAL RESTRAINT SYSTEMS _0334261 FRONT PASSENGER AIRBAG ASSEMBLY(for TMT Made) A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT PASSENGER AIRBAG ASSEMBLY(for TMT Made)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The following procedure is for LHD vehicles.



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55302A 2.REMOVE UPPER INSTRUMENT PANEL SUB-ASSEMBLY

Hide 88625H 3.REMOVE COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)

Hide 89120A 4.REMOVE AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)

Hide 55950G 5.REMOVE DEFROSTER NOZZLE ASSEMBLY

Hide 82142 6.SEPARATE NO. 2 INSTRUMENT PANEL WIRE (for Automatic Air Conditioning System)

a.
B489830

Disengage the 3 clamps to separate the No. 2 instrument panel wire.


Hide 55085 7.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 73960A 8.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY

a.
B487479

Remove the 2 screws.


b.

Disengage the 6 hooks to remove the instrument panel passenger airbag assembly.


Hide 82142A 9.REMOVE INSTRUMENT PANEL WIRE ASSEMBLY

a.
B487480C02
0.656,2.979 0.844,2.615 true 0.417,2.771 0.75,2.438 true 0.479,2.896 0.792,3.052 0.313,0.156 10 false *1 0.219,2.667 0.531,2.823 0.313,0.156 10 false *a
*1 Locking Button
*a Protective Tape


Disengage the clamp to disconnect the instrument panel wire assembly.


b.

Using a screwdriver with the tip wrapped in protective tape, release the locking button.


c.

Disconnect the airbag connector to remove the instrument panel wire assembly from the instrument panel passenger airbag assembly.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.