Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
Use the same procedure for the RH side and LH side.
The procedure listed below is for the LH side.
82142A
1.INSTALL INSTRUMENT PANEL WIRE ASSEMBLY
| *1 | Locking Button |
Connect the airbag connector of the instrument panel wire assembly to the instrument panel passenger airbag assembly.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Push in the locking button to install the airbag connector to the instrument panel passenger airbag assembly.
Securely lock the locking button.
Engage the clamp to connect the instrument panel wire assembly.
73960A
2.INSTALL INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Engage the 6 hooks to install the instrument panel passenger airbag assembly.
Install the 2 screws.
55085
3.INSTALL NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
82142
4.INSTALL NO. 2 INSTRUMENT PANEL WIRE (for Automatic Air Conditioning System)
Engage the 3 clamps to install the No. 2 instrument panel wire.
55950G
5.INSTALL DEFROSTER NOZZLE ASSEMBLY
89120A
6.INSTALL AUTOMATIC LIGHT CONTROL SENSOR (w/ Automatic Light Control System)
88625H
7.INSTALL COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)
55302A
8.INSTALL UPPER INSTRUMENT PANEL SUB-ASSEMBLY
9.INSPECT SRS WARNING LIGHT