Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
55301
3.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY (for Manual Air Conditioning System)
88625H
4.REMOVE COOLER (SOLAR SENSOR) THERMISTOR (for Automatic Air Conditioning System)
55950G
5.REMOVE DEFROSTER NOZZLE ASSEMBLY
55085
6.REMOVE NO. 2 HEATER TO REGISTER DUCT SUB-ASSEMBLY
73970A
7.REMOVE INSTRUMENT PANEL PASSENGER AIRBAG ASSEMBLY
Remove the 2 nuts.
Disengage the 12 claws to remove the instrument panel passenger airbag assembly.
82142A
8.REMOVE INSTRUMENT PANEL WIRE ASSEMBLY
| *1 | Locking Button |
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, release the locking button.
Disconnect the airbag connector to remove the instrument panel wire assembly from the instrument panel passenger airbag assembly.
When disconnecting any airbag connector, take care not to damage the airbag wire harness.