Home › Vehicle Interior › SUPPLEMENTAL RESTRAINT SYSTEMS › FRONT SEAT SIDE AIRBAG ASSEMBLY › from 2017.10
RM30M0E _58 Vehicle Interior _017115 SUPPLEMENTAL RESTRAINT SYSTEMS _0334272 FRONT SEAT SIDE AIRBAG ASSEMBLY A

SUPPLEMENTAL RESTRAINT SYSTEMS  FRONT SEAT SIDE AIRBAG ASSEMBLY  INSTALLATION  


CAUTION / NOTICE / HINT

CAUTION:
·

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION

·

If the side airbag was deployed, replace the front seat airbag assembly, separate type front seatback spring assembly, separate type front seatback cover and separate type front seatback pad with a new one.

·

Wear protective gloves. Sharp areas on the parts may injure your hands.



HINT:

The procedure described below is for the driver side. Use the same procedure for both the driver and front passenger sides, unless otherwise specified.


PROCEDURE

Hide 1.INSTALL FRONT SEAT SIDE AIRBAG ASSEMBLY

CAUTION:
·

The nuts must not be reused.

·

Make sure that the separate type front seatback spring assembly is not deformed. If it is, replace it with a new one.



a.

Install the front seat side airbag assembly with 2 new nuts.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


b.

Engage the 2 clamps.


c.

Engage the loop fastener.


d.

for LH Side:

i.

Engage the claw.


ii.

Engage the 4 clamps to install the front seat side airbag wire harness.



e.

for RH Side:

i.

Engage the claw.


ii.

Engage the 2 clamps to install the front seat side airbag wire harness.



Hide 2.INSTALL SEPARATE TYPE FRONT SEATBACK COVER WITH PAD

Hide 71862 3.INSTALL FRONT SEAT CUSHION INNER SHIELD (for Driver Side)

Hide 71862 4.INSTALL FRONT SEAT CUSHION INNER SHIELD (for Front Passenger Side)

Hide 71812D 5.INSTALL FRONT SEAT CUSHION SHIELD LH

Hide 72495 6.INSTALL VERTICAL ADJUSTING HANDLE (w/ Vertical Adjuster)

Hide 72526A 7.INSTALL RECLINING ADJUSTER RELEASE HANDLE

Hide 71910A 8.INSTALL FRONT SEAT HEADREST ASSEMBLY

Hide 73240 9.INSTALL FRONT SEAT INNER BELT ASSEMBLY

Hide 10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION