The certification ECU (smart key ECU assembly) monitors communication between all the ECUs connected to the certification bus lines. When the certification ECU (smart key ECU assembly) detects errors in communication with all the ECUs connected to the certification bus lines at a set interval and 3 times in a row, DTC B2785 will be stored.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B2785 | Communication Malfunction between ECUs Connected by LIN | ·
Errors in LIN communication between ECUs or an open or short in communication lines ·
LIN communication error detected by the certification ECU (smart key ECU assembly) 3 times in a row. |
·
Certification ECU (smart key ECU assembly) ·
Steering lock ECU (steering lock actuator assembly) ·
Wire harness or connector ·
STRG LOCK fuse |
Inspect the fuses for circuits related to this system before performing the following procedure.
If the certification ECU (smart key ECU assembly) is replaced, register the keys (refer to Service Bulletin).
If the steering lock ECU (steering lock actuator assembly) is replaced, register the ECU code (refer to Service Bulletin).
Before performing the inspection, check that DTC B2786 is not output.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
Disconnect the F43 certification ECU (smart key ECU assembly) connector.
Disconnect the F15 steering lock ECU (steering lock actuator assembly) connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| F43-5 (LIN) - F15-5 (LIN) | Always | Below 1 Ω |
| F43-5 (LIN) - Body ground | Always | 10 kΩ or higher |
| F15-5 (LIN) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Reconnect the F43 certification ECU (smart key ECU assembly) connector.
Clear the DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs.
Click herePower Source / Network>NETWORKING>LIN COMMUNICATION SYSTEM>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC B2785 is output | A |
| DTC B2785 is not output (for TMMIN Made) | B |
| DTC B2785 is not output (for TMT Made) | C |
A
B
C