The Malfunction Indicator Lamp (MIL) is used to indicate vehicle malfunctions detected by the ECM.
The MIL operation can be checked visually:
When the ignition switch is turned ON, the MIL should be illuminated and should then turn off after the engine is started. If the MIL remains illuminated or is not illuminated, conduct the following troubleshooting procedure using the GTS.
Inspect the fuses for circuits related to this system before performing the following procedure.
Perform troubleshooting in accordance with the table below.
| Result | Condition | Proceed to |
|---|---|---|
| Illuminates → Turns off | Ignition switch ON → After engine is started | A |
| Other than above | - | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Check the communication between the GTS and ECM.
The Data List item "Engine and ECT" can be checked.
| Result | Proceed to |
|---|---|
| Communication is possible | A |
| Communication is not possible | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check the DTCs.
| Result | Proceed to |
|---|---|
| DTCs are not output | A |
| DTCs are output | B |
A
B
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: Body Electrical / Combination Meter / Active Test / Check Engine Indicator.
| Tester Display |
|---|
| Check Engine Indicator |
Check the status of the MIL while performing the Active Test.
| Result | Proceed to |
|---|---|
| Changes | A |
| Does not change (for TMMIN Made) | B |
| Does not change (for TMT Made) | C |
A
B
C