Home › Engine / Hybrid System › 2NR-FE COOLING › COOLING FAN MOTOR › 2017.10–2018.01
RM30M0E _51 Engine / Hybrid System _053565 2NR-FE COOLING _0259969 COOLING FAN MOTOR A

2NR-FE COOLING  COOLING FAN MOTOR  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Be sure that the ignition switch is off if you work near the electric cooling fans or radiator grille. With the ignition switch ON, the electric cooling fans may automatically start to run if the engine coolant temperature is high and/or the air conditioning is on (w/ air conditioning system).


PROCEDURE

Hide 53141F 2.REMOVE RADIATOR COVER (for TMMIN Made)

Hide 4.DISCONNECT RADIATOR RESERVOIR TANK HOSE

Hide 16571C 5.DISCONNECT NO. 1 RADIATOR HOSE

Hide 6.REMOVE WIRE HARNESS CLAMP BRACKET

a.
A381688

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 2 clamps to separate the air fuel ratio sensor wire from the wire harness clamp bracket.


c.
A381689

Disengage the clamp to disconnect the wire harness from the wire harness clamp bracket.


d.

Remove the bolt and wire harness clamp bracket from the cylinder head sub-assembly.


Hide 17751 7.REMOVE NO. 1 AIR CLEANER INLET

a.
A412464

Disengage the 3 claws to remove the No. 1 air cleaner inlet from the air cleaner case sub-assembly.


Hide 16711 8.REMOVE FAN SHROUD

a.
A381677

Disconnect the cooling fan motor connector.


b.

Disengage the 3 clamps to disconnect the wire harness from the fan shroud.


c.
A381284

Disengage the 2 claws and 3 guides to remove the fan shroud from the radiator assembly.

NOTICE:

Do not apply any excessive force to the radiator assembly when removing the fan shroud.



Hide 16361 9.REMOVE FAN

a.
A389933

Remove the nut and fan from the cooling fan motor.


Hide 16363 10.REMOVE COOLING FAN MOTOR

a.
A381286

Remove the 3 screws and cooling fan motor from the fan shroud.