1.REMOVE REAR SEAT ASSEMBLY (for Fixed Seat Type)
2.REMOVE REAR SEAT ASSEMBLY (for Separate Seat Type)
67914
3.REMOVE FRONT DOOR SCUFF PLATE LH
67918A
4.REMOVE REAR DOOR SCUFF PLATE LH
62112
5.REMOVE COWL SIDE TRIM BOARD LH
62312B
6.REMOVE FRONT DOOR OPENING TRIM WEATHERSTRIP LH
62332A
7.REMOVE REAR DOOR OPENING TRIM WEATHERSTRIP LH
73220
8.DISCONNECT FRONT SEAT OUTER BELT ASSEMBLY LH
62414A
9.REMOVE CENTER PILLAR LOWER GARNISH LH
62552F
10.REMOVE REAR SEAT SIDE GARNISH LH
64711
11.REMOVE LUGGAGE COMPARTMENT FLOOR MAT
Remove the luggage compartment floor mat.
64770
12.REMOVE SPARE WHEEL COVER ASSEMBLY
Remove the spare wheel cover assembly.
64772
13.REMOVE SPARE WHEEL COVER PAD
Remove the spare wheel cover pad.
64773B
14.REMOVE NO. 2 SPARE WHEEL COVER PAD
Use the same procedure as for the spare wheel cover pad.
58387
15.REMOVE REAR FLOOR FINISH PLATE
Using a clip remover, remove the 2 clips.
Disengage the 4 claws and the 6 guides and remove the rear floor finish plate.
64722B
16.REMOVE NO. 2 LUGGAGE COMPARTMENT TRIM COVER
Using a clip remover, remove the 3 clips and the No. 2 luggage compartment trim cover.
77306
17.REMOVE FUEL LID LOCK OPEN LEVER SUB-ASSEMBLY
Remove the screw.
Disengage the hook and separate the fuel lid lock open lever sub-assembly in the direction indicated by the arrow as shown in the illustration.
| *1 | Luggage Door Lock Control Cable Assembly |
| *2 | Fuel Lid Lock Control Cable Assembly |
Disengage the 2 guides, disconnect the fuel lid lock control cable sub-assembly and luggage door lock control cable sub-assembly and remove the fuel lid lock open lever sub-assembly.
58510D
18.SEPARATE FRONT FLOOR CARPET ASSEMBLY
Disengage the 2 guides to peel back the front floor carpet assembly from the driver side front floor.
Disengage the guide to peel back the front floor carpet assembly from the left side of the driver side rear floor.
77377
19.REMOVE FUEL FILLER OPENING LID LOCK RETAINER
Disengage the 2 claws and disconnect the fuel lid lock control cable sub-assembly from the fuel filler opening lid lock retainer.
Disengage the 2 claws.
| *a | Guide |
| *b | Slit |
Align the 2 guides with the 2 slits, and remove the fuel filler opening lid lock retainer.
77035
20.REMOVE FUEL LID LOCK CONTROL CABLE SUB-ASSEMBLY
Remove the fuel lid lock control cable sub-assembly from the 5 clamps as shown in the illustration.
| *1 | Fuel Lid Lock Control Cable Sub-assembly | - | - |
| *a | Clamp | - | - |