Use the same procedure for both the RH side and LH sides.
The procedure described below is for the LH side.
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (for Hatchback).
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
67492A
3.REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH
74220
4.REMOVE FRONT ARMREST ASSEMBLY
74232
5.REMOVE FRONT ARMREST BASE UPPER PANEL
67602
6.REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY
68172A
7.REMOVE FRONT DOOR GLASS INNER WEATHERSTRIP
67832
8.REMOVE FRONT DOOR SERVICE HOLE COVER
68102
9.REMOVE FRONT DOOR GLASS SUB-ASSEMBLY
68151D
10.REMOVE FRONT DOOR GLASS RUN
67404F
11.REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY
12.REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY (w/ Lock Cylinder)
69320
13.REMOVE FRONT DOOR LOCK ASSEMBLY
Disconnect the connector.
Using a T30 "TORX" socket wrench, remove the 3 screws.
Slide the front door lock assembly downward, and remove the front door lock assembly and cables as a unit.
When reusing the front door lock assembly:
Remove the door lock wiring harness seal from the front door lock assembly.
69760C
14.REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY
Disengage the 5 claws and open the cover in the direction indicated by the arrow as shown in the illustration.
Disengage the guide and remove the front door inside locking cable assembly from the front door lock assembly.
69720B
15.REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY
Disengage the guide and remove the front door lock remote control cable assembly from the front door lock assembly.