89348S
1.INSTALL REAR CENTER ULTRASONIC SENSOR RETAINER (w/ Clearance Sonar System)
89342A
2.INSTALL REAR CENTER ULTRASONIC SENSOR (w/ Clearance Sonar System)
89348D
3.INSTALL ULTRASONIC SENSOR CLIP (w/ Clearance Sonar System)
82182
4.INSTALL NO. 2 LUGGAGE ROOM WIRE (w/ Clearance Sonar System)
Connect the connector and engage the clamp.
Use the same procedures for the opposite side.
Install the No. 2 luggage room wire.
52023
5.INSTALL REAR BUMPER REINFORCEMENT SUB-ASSEMBLY
Engage the 2 guides and install the rear bumper reinforcement sub-assembly.
Install the 2 bolts.
19 N*m (194 kgf*cm, 14 ft.*lbf)
75895N
6.INSTALL NO. 1 MOULDING TAPE
| *a | Location Line |
Install the new No.1 moulding tape as shown in the illustration.
Install the No.1 moulding tape along the location line on the rear bumper.
52563A
7.INSTALL REAR BUMPER UPPER RETAINER LH
Install the rear bumper upper retainer LH with the screw.
52562B
8.INSTALL REAR BUMPER UPPER RETAINER RH
Use the same procedure as for the LH side.
81560
9.INSTALL REAR COMBINATION LIGHT ASSEMBLY LH
81550
10.INSTALL REAR COMBINATION LIGHT ASSEMBLY RH
Use the same procedure as for the LH side.
52576
11.INSTALL REAR BUMPER SIDE RETAINER LH
Engage the 3 claws and install the rear bumper side retainer LH.
Install the screw grommet.
Install the 2 screws.
52575
12.INSTALL REAR BUMPER SIDE RETAINER RH
Use the same procedure as for the LH side.
81920
13.INSTALL REFLEX REFLECTOR ASSEMBLY LH (w/o Rear Fog Light)
Engage the guide and install the reflex reflector assembly LH.
Install the 2 screws.
81910
14.INSTALL REFLEX REFLECTOR ASSEMBLY RH (w/o Rear Fog Light)
Use the same procedure as for the LH side.
81590B
15.INSTALL REAR FOG LIGHT ASSEMBLY LH (w/ Rear Fog Light)
81580H
16.INSTALL REAR FOG LIGHT ASSEMBLY RH (w/ Rear Fog Light)
Use the same procedure as for the LH side.