1.REMOVE REAR WHEELS
2.DRAIN BRAKE FLUID
89516D
3.SEPARATE SKID CONTROL SENSOR WIRE LH
89516C
4.SEPARATE SKID CONTROL SENSOR WIRE RH
Use the same procedure described for the LH side.
47319F
5.SEPARATE REAR FLEXIBLE HOSE LH
47318F
6.SEPARATE REAR FLEXIBLE HOSE RH
Use the same procedure described for the LH side.
47324
7.REMOVE REAR NO. 4 BRAKE TUBE
Using a 10 mm union nut wrench, remove the rear No. 4 brake tube while holding the rear flexible hose with a wrench.
Do not kink or damage the brake line.
Do not allow any foreign matter such as dirt and dust to enter the brake line.
Remove the clip and separate the rear flexible hose.
47323
8.REMOVE REAR NO. 3 BRAKE TUBE
Use the same procedure described for the rear No. 4 brake tube.
58251D
9.REMOVE FRONT FLOOR PANEL BRACE LH
58251D
10.REMOVE FRONT FLOOR PANEL BRACE RH
Use the same procedure described for the LH side.
58910C
11.REMOVE REAR CONSOLE BOX ASSEMBLY (for Separate Type)
58910C
12.REMOVE REAR CONSOLE BOX ASSEMBLY (for Integrated Type)
13.LOOSEN PARKING BRAKE CABLE
46430
14.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY
15.SEPARATE NO. 2 PARKING BRAKE CABLE ASSEMBLY
Use the same procedure described for the No. 3 parking brake cable assembly.
16.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY LH
17.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY RH
Use the same procedure described for the LH side.
18.REMOVE REAR DISC
42450B
19.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY LH
42450A
20.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY RH
Use the same procedure described for the LH side.
42110F
21.LOOSEN REAR AXLE BEAM ASSEMBLY
48231B
22.REMOVE REAR COIL SPRING LH
48231A
23.REMOVE REAR COIL SPRING RH
Use the same procedure described for the LH side.
42110F
24.REMOVE REAR AXLE BEAM ASSEMBLY
Support the rear axle beam assembly with an engine lifter using the 4 plate lift attachments or equivalent tools as shown in the illustration.
| *a | Plate Lift Attachment | *b | Engine Lifter |
Make sure to secure the rear axle beam assembly to prevent it from dropping.
Remove the 2 bolts A and separate the rear axle beam assembly from the rear shock absorber assemblies LH and RH.
Remove the 2 bolts B and rear axle beam assembly from the body.
48725G
25.REMOVE REAR AXLE CARRIER BUSH LH
| *a | Bush Rib |
| *b | Alignment Mark |
| *c | Hold |
| *d | Turn |
Place a matchmark on the rear axle beam assembly with it aligned with the alignment mark of the rear axle carrier bush LH.
Using a chisel and hammer, bend the 2 portions of the bush rib.
Bend the bush rib until the claw of SST can be suspended.
When removing the bush, do not rub off the matchmark on the rear axle beam assembly.
Using SST, remove the rear axle carrier bush LH from the rear axle beam assembly.
Apply grease to the threads and tip of the SST center bolt before use.
48725F
26.REMOVE REAR AXLE CARRIER BUSH RH
Use the same procedure described for the LH side.