Use the same procedure for LHD and RHD vehicles.
The procedure listed below is for the LHD vehicles.
55661A
1.REMOVE INSTRUMENT PANEL REGISTER BEZEL
55411G
2.REMOVE NO. 1 INSTRUMENT CLUSTER FINISH PANEL
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>REMOVAL
45287
3.REMOVE LOWER STEERING COLUMN COVER
Removing the steering column lower cover in the incorrect order will cause the parts to break.
Turn the steering wheel assembly to the left and remove the screw.
Turn the steering wheel assembly to the right and remove the screw.
Remove the screw.
Disengage the 3 claws to remove the lower steering column cover.
45286B
4.REMOVE UPPER STEERING COLUMN COVER
84650
5.REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY
Disconnect the 2 connectors.
| *a | Protective Tape |
Using a screwdriver with its tip wrapped in protective tape, disengage the claw to remove the windshield wiper switch assembly.
Do not press the claw too hard, as it may be damaged.