Home › Vehicle Exterior › LIGHTING (EXT) › STOP LIGHT SWITCH › from 2018.01
RM30M0E _59 Vehicle Exterior _017126 LIGHTING (EXT) _0092618 STOP LIGHT SWITCH A

LIGHTING (EXT)  STOP LIGHT SWITCH  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for RHD and LHD vehicles.

·

The procedure listed below is for LHD vehicles.



PROCEDURE

Hide 84345 1.INSTALL STOP LIGHT SWITCH MOUNTING ADJUSTER

Hide 84340 2.INSTALL STOP LIGHT SWITCH ASSEMBLY

a.
E167768

Install the stop light switch assembly into the adjuster until it slightly touches the brake pedal.

NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



b.
E236346E01
1.552,1.938 1.865,2.177 0.313,0.24 10 a

Turn the stop light switch assembly a quarter turn clockwise to install the stop light switch assembly.

Torque:
1.5 N*m (15 kgf*cm, 13 in.*lbf)

or less


NOTICE:

When inserting the stop light switch assembly, support the pedal from behind so that the pedal is not pushed in.



c.

Connect the connector.


d.

Check the protrusion of the plunger.

Protrusion of Plunger
Area Measurement
a 0.5 to 2.6 mm (0.020 to 0.102 in.)

If the protrusion is not as specified, recheck switch installation and inspect brake pedal adjustment if necessary.

Click hereBrake>BRAKE SYSTEM (OTHER)>BRAKE PEDAL(for LHD)>ADJUSTMENT

NOTICE:

Do not depress or support the brake pedal.



Hide 73900 3.INSTALL LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 55432B 4.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

Hide 55480D 5.INSTALL LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY (w/o Knee Airbag)

Hide 55606 6.INSTALL NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)