Use the same procedure for the RH and LH sides.
The procedure described below is for the LH side.
1. REPAIR INSTRUCTION
75924
2.INSTALL NO. 2 BLACK OUT TAPE (for Sedan)
Clean the attachment surface (Using an infrared light).
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION
Clean the attachment surface (Using a tape removal disc).
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION
| *a | Perforation |
| *b | Remove |
Remove the portion of a new No. 2 black out tape at the perforation as shown in the illustration.
Apply the No. 2 black out tape to the positions shown in the illustration.
| Dimension | Measurement |
|---|---|
| a | 2.0 to 4.0 mm (0.0787 to 0.157 in.) |
| b | 4.0 to 6.0 mm (0.158 to 0.236 in.) |
Remove the release paper and apply the No. 2 black out tape.
75924
3.INSTALL NO. 2 BLACK OUT TAPE (for Hatchback)
Clean the attachment surface (Using an infrared light).
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION
Clean the attachment surface (Using a tape removal disc).
Click hereVehicle Exterior>EXTERIOR PANELS / TRIM>BLACK OUT TAPE(for Front Door)>INSTALLATION
| *a | Perforation |
| *b | Remove |
Remove the portion of a new No. 2 black out tape at the perforation as shown in the illustration.
Apply the No. 2 black out tape to the positions shown in the illustration.
| Dimension | Measurement |
|---|---|
| a | 2.0 to 4.0 mm (0.0788 to 0.157 in.) |
| b | 4.0 to 6.0 mm (0.158 to 0.236 in.) |
Remove the release paper and apply the No. 2 black out tape.
68124B
4.INSTALL REAR DOOR QUARTER WINDOW GLASS
75762A
5.INSTALL REAR DOOR WINDOW FRAME FRONT MOULDING