Home › Vehicle Exterior › WINDOW / GLASS › WINDSHIELD GLASS › from 2018.01
RM30M0E _59 Vehicle Exterior _017121 WINDOW / GLASS _0092746 WINDSHIELD GLASS A

WINDOW / GLASS  WINDSHIELD GLASS  REMOVAL  


PROCEDURE

Hide 55781E 1.REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY

Hide 87810 2.REMOVE INNER REAR VIEW MIRROR ASSEMBLY

Hide 62312B 3.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH

a.

Disconnect the front door opening trim weatherstrip LH to the extent that the front pillar garnish LH can be removed.


Hide 62311B 4.DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP RH

HINT:

Use the same procedure as for the LH side.


Hide 62212 5.REMOVE FRONT PILLAR GARNISH LH

Hide 62211 6.REMOVE FRONT PILLAR GARNISH RH

HINT:

Use the same procedure as for the LH side.


Hide 81260A 7.REMOVE MAP LIGHT ASSEMBLY

Hide 74610A 8.REMOVE ASSIST GRIP SUB-ASSEMBLY

Hide 74310 10.REMOVE VISOR ASSEMBLY RH

HINT:

Use the same procedure as for the LH side.


Hide 74348B 12.REMOVE VISOR HOLDER RH

HINT:

Use the same procedure as for the LH side.


Hide 63310 13.REMOVE ROOF HEADLINING ASSEMBLY

a.

Slightly lower the front section of the roof headlining assembly so that the windshield glass can be removed.

NOTICE:

Do not damage the roof headlining assembly or body interior.


HINT:

It is not necessary to completely remove the roof headlining assembly.



Hide 56111 14.REMOVE WINDSHIELD GLASS

a.
B343870C01
0,0 0.26,0 false
V100155

Protective Tape


Apply protective tape to the installation area on the windshield glass on the vehicle body.


b.
B343871C01
0.396,1.781 0.688,1.698 true 1.031,0.417 1.292,0.896 false 1.323,1.677 1.052,1.479 false 0.229,1.708 0.542,1.906 0.313,0.198 10 false *a 1.375,1.677 1.688,1.875 0.313,0.198 10 false *c 0.906,0.24 1.219,0.438 0.313,0.198 10 false *b
*a Wooden Block
*b Plastic Sheet
*c Piano Wire


Pass a piano wire between the vehicle body and windshield glass from the interior.


c.

Tie objects that can serve as handles (for example, wooden blocks) to both wire ends.


d.

Cut off the adhesive by pulling the piano wire around the windshield glass.

NOTICE:
·

When separating the windshield glass, take care not to damage the paint or interior and exterior ornaments.

·

To prevent the safety pad from being scratched when removing the windshield glass, place a plastic sheet between the piano wire and safety pad.




e.
B343872C05
2.146,0.646 2.354,0.917 2.354,0.917 2.333,0.427 true 2.302,0.938 2.615,1.135 0.313,0.198 10 false *a
*a Matchmarks


Place matchmarks on the windshield glass and vehicle body on the locations indicated in the illustration.

HINT:

Matchmarks are not necessary if the windshield glass is not going to be reused.



f.

Using suction cups, disengage the windshield glass stopper and remove the windshield glass.

B343869C01
4.75,0.667 5,0.458 false 5,0.833 5.167,0.677 false 1.5,0.75 1.813,0.75 false 0.021,0.021 0.333,0.177 0.313,0.156 12 false *A 3.521,0.031 3.833,0.188 0.313,0.156 12 false *B 1.333,0.656 1.646,0.813 0.313,0.156 10 false *1 4.563,0.594 4.875,0.75 0.313,0.156 10 false *2 4.833,0.74 5.146,0.896 0.313,0.156 10 false *1
*A for 1-piece Type *B for 2-piece Type
*1 No. 1 Windshield Glass Stopper *2 No. 2 Windshield Glass Stopper


NOTICE:
·

Be careful not to drop the windshield glass.

·

Leave as much adhesive on the vehicle body as possible when removing the windshield glass.

·

To prevent the windshield glass from dropping when performing this operation, be sure to hold the windshield glass using suction cups.

·

There are No. 2 windshield glass stoppers and No. 1 windshield glass stoppers on the windshield glass. Be careful not to damage the windshield glass when cutting off the adhesive.



HINT:

Depending on vehicles, 1-piece or 2-piece type stoppers are used.



g.

Using suction cups, remove the windshield glass.

NOTICE:
·

Be careful not to drop the windshield glass.

·

Leave as much adhesive on the vehicle body as possible when removing the windshield glass.




Hide 56117D 15.REMOVE WINDSHIELD GLASS ADHESIVE DAM

a.
B347334C01
0.073,0.063 0.385,0.26 0.313,0.198 10 false *a
*a Back Side


Using a scraper, remove the 4 windshield glass adhesive dams.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the windshield glass adhesive dam with a new one.




Hide 56115A 16.REMOVE NO. 1 WINDSHIELD GLASS STOPPER (for 1-piece Type)

a.
B347335C01
0.063,0.052 0.375,0.25 0.313,0.198 10 false *a
*a Back Side


Using a scraper, remove the 2 No. 1 windshield glass stoppers.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the 1-piece type No. 1 windshield glass stoppers with a new pair of 2-piece type No. 1 and No. 2 windshield glass stoppers.




Hide 56116C 17.REMOVE NO. 2 WINDSHIELD GLASS STOPPER (for 2-piece Type)

a.
B347336C01
0.073,0.042 0.385,0.24 0.313,0.198 10 false *a
*a Back Side


Using a scraper, remove the 2 No. 2 windshield glass stoppers.

NOTICE:
·

Be careful not to damage the windshield glass.

·

Be sure to replace the No. 2 windshield glass stoppers with new ones.




Hide 56115A 18.REMOVE NO. 1 WINDSHIELD GLASS STOPPER (for 2-piece Type)

a.
B343874

Remove the 2 No. 1 windshield glass stoppers.

NOTICE:

Be sure to replace the No. 1 windshield glass stoppers with new ones.