If the manual up and down function can be performed but the auto up and down function cannot, then the fail-safe mode may be functioning.
If the power window initialization has not been performed, the auto up and down function will not operate.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
When the front power window regulator motor assembly (driver side) is reinstalled or replaced, the power window control system must be initialized.
Replacing the door glass or door glass run may cause a difference to exist between the current door glass position and the position memorized in the ECU. In this case, the jam protection function may work improperly. Return the system to the pre-initialized condition and reinitialize the system.
Disconnect the power window regulator motor connector during power window operation. This will return the motor to the pre-initialized condition.
The auto up function will not work unless initialization is completed.
Remove the power window regulator master switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL
Inspect the power window regulator master switch assembly.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW MASTER SWITCH>REMOVAL
| Proceed to |
|---|
| OK |
| NG |
OK
NG
for LHD
Disconnect the H8 power window regulator master switch assembly connector.
Disconnect the H11 front power window regulator motor assembly LH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| H8-4 (A) - H11-4 (AUTO) | Always | Below 1 Ω |
| H8-4 (A) or H11-4 (AUTO) - Body ground | Always | 10 kΩ or higher |
for RHD
Disconnect the G5 power window regulator master switch assembly connector.
Disconnect the G11 front power window regulator motor assembly RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| G5-4 (A) - G11-4 (AUTO) | Always | Below 1 Ω |
| G11-4 (AUTO) or G5-4 (A) - Body ground | Always | 10 kΩ or higher |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Initialize the front power window regulator motor assembly (driver side).
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>INITIALIZATION
| Proceed to |
|---|
| NEXT |
NEXT
Check that the driver side door power window moves when the auto up and down function of the power window regulator master switch assembly and are operated.
Click hereVehicle Exterior>WINDOW / GLASS>POWER WINDOW CONTROL SYSTEM>OPERATION CHECK
Driver side auto up and down function is normal.
| Proceed to |
|---|
| OK |
| NG |
OK
NG