84540
1.INSTALL PARK/NEUTRAL POSITION SWITCH
Temporarily install the park/neutral position switch to the continuously variable transaxle assembly with the 2 bolts.
Install the lock nut and lock plate to the park/neutral position switch.
Temporarily install the control shaft lever.
Turn the control shaft lever clockwise until it stops, and then from that position turn it counterclockwise by 2 notches to set it to the N position.
Remove the control shaft lever.
| *a | Neutral Basic Line |
| *b | Protrusion |
Align the protrusion with the neutral basic line.
Hold the park/neutral position switch in that position and tighten the 2 bolts.
Using a screwdriver, bend down the tabs of the lock plate.
Install the control shaft lever to the continuously variable transaxle assembly with the nut and washer.
Connect the park/neutral position switch connector.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
To prevent damage to the transmission control cable assembly and transmission floor shift assembly, connect the continuously variable transaxle assembly side of the transmission control cable assembly before connecting the transmission floor shift assembly side.
Connect the transmission control cable assembly to the No. 1 transmission control cable bracket with a new clip.
Connect the transmission control cable assembly to the control shaft lever with the nut.
Before connecting the transmission control cable assembly, check that the park/neutral position switch and shift lever are in neutral.
Confirm that the shift lever is in N, and then connect the end of the transmission control cable assembly to the transmission floor shift assembly.
Securely install the end of the transmission control cable assembly to the transmission floor shift assembly.
Install the end of the transmission control cable assembly so that its adjustment lock section is on the driver side.
74410
3.INSTALL BATTERY CARRIER ASSEMBLY
74431
4.INSTALL BATTERY TRAY
28800
5.INSTALL BATTERY
17701
6.INSTALL AIR CLEANER CASE SUB-ASSEMBLY
17801
7.INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY
8.INSTALL AIR CLEANER CAP SUB-ASSEMBLY
17880
9.INSTALL AIR CLEANER HOSE ASSEMBLY
10.CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
11.INSPECT SHIFT LEVER POSITION
12.ADJUST SHIFT LEVER POSITION
58810J
13.INSTALL CONSOLE BOX ASSEMBLY
58839A
14.INSTALL CONSOLE BOX HOLE COVER
58916
15.INSTALL BOX BOTTOM MAT
58912C
16.INSTALL NO. 2 BOX SIDE PANEL
58911A
17.INSTALL NO. 1 BOX SIDE PANEL
58817A
18.INSTALL NO. 2 FRONT CONSOLE BOX INSERT
58816D
19.INSTALL NO. 1 FRONT CONSOLE BOX INSERT
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION
58910C
20.INSTALL REAR CONSOLE BOX ASSEMBLY
84540
21.INSPECT PARK/NEUTRAL POSITION SWITCH
84540
22.ADJUST PARK/NEUTRAL POSITION SWITCH