33530F
1.INSTALL FLOOR SHIFT SHIFT LEVER ASSEMBLY
Install the floor shift shift lever assembly to the body with the 4 bolts.
Engage the 2 clamps to install the wire harness to the floor shift shift lever assembly.
33820B
2.CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY
| *1 | Nut |
| *2 | Lock |
|
Rotate approximately 180° |
|
Push in |
Rotate the 2 nuts of the transmission control cable assembly approximately 180° in the direction shown in the illustration, and while holding the nut, push in the lock.
Do not rotate the nut excessively as it may damage the internal spring and the transmission control cable assembly will not be reusable.
| *1 | Clip A |
| *2 | Clip B |
| *3 | Lock |
| *a | Protrusion |
Install the transmission control cable assembly to the floor shift shift lever assembly.
Install the transmission control cable assembly with the protrusion of the cable outer facing upwards.
After installation, make sure that the lock is projecting from A as shown in the illustration.
Engage the clip B to connect the shift cable end of the transmission control cable assembly to the floor shift shift lever assembly.
Connect the select cable end of the transmission control cable assembly to the floor shift shift lever assembly with the clip A.
Install the transmission control cable assembly with the protrusion of the select cable end facing upwards.
Perform the installation with the clip A at the correct direction as shown in the illustration.
58810J
3.INSTALL CONSOLE BOX ASSEMBLY
58839A
4.INSTALL CONSOLE BOX HOLE COVER
58916
5.INSTALL BOX BOTTOM MAT
58912C
6.INSTALL NO. 2 BOX SIDE PANEL
58911A
7.INSTALL NO. 1 BOX SIDE PANEL
58817A
8.INSTALL NO. 2 FRONT CONSOLE BOX INSERT
58816D
9.INSTALL NO. 1 FRONT CONSOLE BOX INSERT
for LHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>UPPER INSTRUMENT PANEL>INSTALLATION
for RHD:
Click hereVehicle Interior>INTERIOR PANELS / TRIM>LOWER INSTRUMENT PANEL>INSTALLATION
58910C
10.INSTALL REAR CONSOLE BOX ASSEMBLY