Home › Drivetrain › AXLE AND DIFFERENTIAL › FRONT AXLE HUB › from 2018.01
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090087 FRONT AXLE HUB A

AXLE AND DIFFERENTIAL  FRONT AXLE HUB  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE FRONT WHEEL

Hide 53876A 2.REMOVE FRONT FENDER LINER

a.
C380893C01
1,3.917 1.448,3.438 false 0.854,3.917 1.167,4.115 0.313,0.198 10 false *a
*a Protective Tape


Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the pin hold clip from the front fender liner retainer.


b.

Remove the 7 clips, 3 screws, 4 grommets and the front fender liner from the body.

C380889


Hide 3.SEPARATE FRONT SPEED SENSOR WIRE

a.
C282319

Disconnect the front speed sensor connector.


b.

Disengage the 2 clamps from the body.


c.
C282320

Disengage the 3 clamps.


d.

Remove the 2 bolts and separate the front speed sensor wire and front flexible hose from the body and front shock absorber assembly.


Hide 5.SEPARATE FRONT DISC BRAKE CALIPER ASSEMBLY

Hide 43512 6.REMOVE FRONT DISC

Hide 43502C 7.REMOVE FRONT AXLE HUB SUB-ASSEMBLY

a.
C282325C01
2.771,1.125 3.021,0.802 3.021,0.802 2.906,1.427 true 3,0.646 3.313,0.802 0.313,0.156 10 false *a
*a Matchmark


Put matchmarks on the front drive shaft assembly and front axle hub sub-assembly.


b.

Using a plastic hammer, tap the end of the front drive shaft assembly and separate the fitting between the front drive shaft assembly and front axle hub sub-assembly.

NOTICE:

Be careful not to damage the thread portion of the front drive shaft assembly.


HINT:

If it is difficult to separate the front drive shaft assembly from the front axle hub sub-assembly, tap the end of the front drive shaft assembly using a brass bar and a hammer.



c.
C282326

Remove the 3 bolts, front axle hub sub-assembly and front disc brake dust cover from the steering knuckle.

NOTICE:
·

Do not place the front speed sensor side so that it is facing downward, and do not allow the front speed sensor side to become damaged or contact foreign matter.

·

Do not drop the front axle hub sub-assembly.

·

Be careful not to damage the drive shaft boot.



HINT:

The front axle hub sub-assembly is a component of the front speed sensor.