Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB(for Rear Disc Brake) › from 2018.01
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090090 REAR AXLE HUB(for Rear Disc Brake) G

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Rear Disc Brake)  ON-VEHICLE INSPECTION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 3.LOOSEN PARKING BRAKE CABLE

Hide 46430 4.SEPARATE NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 5.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 42431 6.REMOVE REAR DISC

Hide 7.INSPECT REAR AXLE HUB BEARING LOOSENESS

a.
C286962

Using a dial indicator, check for looseness near the center of the rear axle hub and bearing assembly.

Maximum looseness:

0.05 mm (0.00197 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Keep the magnet of the dial indicator away from the rear speed sensor.



If the looseness is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 8.INSPECT REAR AXLE HUB RUNOUT

a.
C286963

Using a dial indicator, check for runout on the surface of the rear axle hub and bearing assembly outside the rear axle hub bolt.

Maximum runout:

0.07 mm (0.00276 in.)


NOTICE:
·

Ensure that the dial indicator is set perpendicular to the measurement surface.

·

Make sure to set the tip of the dial indicator towards the outside of the rear axle hub bolts.

·

Keep the magnet of the dial indicator away from the rear speed sensor.



If the runout is more than the maximum, replace the rear axle hub and bearing assembly.


Hide 42431 9.INSTALL REAR DISC

Hide 10.INSTALL REAR DISC BRAKE CALIPER ASSEMBLY

Hide 46430 11.INSTALL NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 12.INSTALL REAR WHEEL

Torque:
103 N*m (1050 kgf*cm, 76 ft.*lbf)

Hide 13.INSPECT AND ADJUST PARKING BRAKE LEVER TRAVEL

Hide 58910C 14.INSTALL REAR CONSOLE BOX ASSEMBLY