Home › Drivetrain › AXLE AND DIFFERENTIAL › REAR AXLE HUB(for Rear Disc Brake) › from 2018.01
RM30M0E _52 Drivetrain _017093 AXLE AND DIFFERENTIAL _0090090 REAR AXLE HUB(for Rear Disc Brake) A

AXLE AND DIFFERENTIAL  REAR AXLE HUB(for Rear Disc Brake)  REMOVAL  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the RH side and LH side.

·

The procedure listed below is for the LH side.



PROCEDURE

Hide 1.REMOVE REAR WHEEL

Hide 58910C 2.REMOVE REAR CONSOLE BOX ASSEMBLY

Hide 3.LOOSEN PARKING BRAKE CABLE

Hide 46430 4.DISCONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY

Hide 5.SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY

Hide 7.DISCONNECT SKID CONTROL SENSOR WIRE

a.
C282356

Using a screwdriver, disengage the claw of the connector lock portion and disconnect the skid control sensor wire connector.


Hide 8.REMOVE REAR AXLE HUB AND BEARING ASSEMBLY

a.
C290891

Remove the 4 bolts and rear axle hub and bearing assembly from the rear axle beam assembly.

NOTICE:
·

Do not place the rear speed sensor side so that it is facing downward, and do not allow the rear speed sensor side to become damaged or contact foreign matter.

·

Do not drop the rear axle hub and bearing assembly.



HINT:

The rear axle hub and bearing assembly is a component of the rear speed sensor.