Home › Vehicle Interior › THEFT DETERRENT / KEYLESS ENTRY › THEFT DETERRENT SYSTEM › from 2018.01
RM30M0E _58 Vehicle Interior _017111 THEFT DETERRENT / KEYLESS ENTRY _0090853 THEFT DETERRENT SYSTEM J

THEFT DETERRENT / KEYLESS ENTRY  THEFT DETERRENT SYSTEM  While Alarm is Armed, Battery is Reconnected but Alarm does not Sound  


DESCRIPTION

While the alarm is armed, the EEPROM inside the body computer will remember the armed state even if the battery is disconnected, and the alarm will sound when the battery is reconnected.

If the alarm does not sound when the battery is reconnected, the alarm may not have been set, or there may be a malfunction in the body computer.

WIRING DIAGRAM

E383632E02
0.552,0.729 1.677,1.406 1.125,0.677 10 false from Door Control Battery*1 0.125,1.74 1.167,2 1.042,0.26 10 false from Battery*2 2.146,1.885 3.219,2.333 1.073,0.448 10 false D/L NO. 1 5.573,1.74 5.885,1.938 0.313,0.198 10 false MB 5.625,1.542 5.938,1.74 0.313,0.198 10 false 6 4.229,1.74 4.542,1.938 0.313,0.198 10 false 6O 5.906,2.885 6.979,3.333 1.073,0.448 10 false Body Computer 4.125,2.677 5.802,3.146 1.677,0.469 10 false Driver Side Junction Block Assembly 4.281,1.531 4.594,1.729 0.313,0.198 10 false 1 0.156,3.031 2.021,3.365 1.865,0.333 10 false *1: w/ Door Control Battery 5.854,1.729 6.448,1.969 0.594,0.24 10 false BECU 0.167,3.385 2.031,3.719 1.865,0.333 10 false *2: w/o Door Control Battery

CAUTION / NOTICE / HINT

NOTICE:

Inspect the fuses for circuits related to this system before performing the following inspection procedures.


PROCEDURE

1.CHECK SECURITY INDICATOR LIGHT OPERATION
a.

Close all doors, the luggage compartment door*1 and the engine hood.

*1: for Sedan



b.

Lock the doors using wireless operation or entry operation*2.

*2: w/ Smart Entry and Start System



c.

Check that the security indicator light illuminates.


d.

After 30 seconds have elapsed, check that the security indicator light changes from illuminated to flashing.


HINT:

The illumination status of the security indicator light can be used to determine whether the theft deterrent system is set or unset.


Result:
Proceed to
OK
NG



OK

2.CHECK VEHICLE CONDITION

NG

2.CHECK VEHICLE CONDITION
a.

When any of the following conditions are met, reconnect the battery.

·

Driver side door is unlocked.

·

The engine hood is open.

·

Any door is opened.

·

The luggage compartment door is opened.*1

*1: for Sedan




OK:

Alarm sounds.


Result:
Result Proceed to
OK A
NG (w/ Door Control Battery) B
NG (w/o Door Control Battery) C



A

END (SYSTEM NORMAL)

B

3.CHECK BODY COMPUTER

C

3.CHECK BODY COMPUTER
a.

Disconnect the battery.


b.

Disconnect the driver side junction block assembly connectors.


c.
E383631C01
1.333,0.5 1.833,0.75 0.5,0.25 0.083,0.083 0.417,0.281 0.333,0.198 10 false *a 1.49,0.552 1.802,0.75 0.313,0.198 10 false 6O
*a Front view of wire harness connector
(to Driver Side Junction Block Assembly)


Measure the resistance according to the value(s) in the table below.

HINT:

Perform the measurement within 30 minutes after disconnecting the battery.


Standard Voltage:
Tester Connection Condition Specified Condition
6O-1 - Body ground Ignition switch off 11 to 14 V



Result:
Proceed to
OK
NG



OK

END (SYSTEM NORMAL)

NG