Home › Engine / Hybrid System › 1NR-FE STARTING › ENGINE SWITCH(for LHD) › from 2018.01
RM30M0E _51 Engine / Hybrid System _053949 1NR-FE STARTING _0335431 ENGINE SWITCH(for LHD) A

1NR-FE STARTING  ENGINE SWITCH(for LHD)  REMOVAL  


CAUTION / NOTICE / HINT

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>PRECAUTION


PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


Hide 2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.


NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION


Hide 55606 3.REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

Hide 55480D 4.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL ASSEMBLY

Hide 55432B 5.REMOVE LOWER INSTRUMENT PANEL FINISH PANEL (w/o Knee Airbag)

Hide 73900 6.REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (w/ Knee Airbag)

Hide 45287 7.REMOVE LOWER STEERING COLUMN COVER

Hide 89611 8.REMOVE ENGINE SWITCH

a.
A307903

Disengage the 2 claws to separate the engine switch from the No. 2 lower center instrument panel finish panel.


b.

Disconnect the engine switch connector to remove the engine switch.