Use the same procedure for the RH side and LH side
The following procedure is for the LH side.
48760B
1.INSTALL REAR SUSPENSION SUPPORT ASSEMBLY
Install the rear suspension support assembly to the rear shock absorber assembly.
48540
2.TEMPORARILY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
Insert the upper end of the rear shock absorber assembly with rear suspension support assembly into the vehicle body.
Temporarily install the rear shock absorber assembly to the rear axle beam assembly with the bolt and nut.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
Insert the bolt with the threaded end facing the inside of the vehicle.
48755
3.INSTALL REAR SUSPENSION SUPPORT
Install the rear suspension support to the rear shock absorber assembly.
| *a | Correct |
| *b | Incorrect |
Make sure that the rear suspension support is correctly installed as shown in the illustration.
48597A
4.INSTALL REAR SHOCK ABSORBER CUSHION RETAINER
Install the rear shock absorber cushion retainer to the rear shock absorber assembly
| *a | Torque Wrench Fulcrum Length |
| *b | Turn |
| *c | Hold |
While using a 5 mm hexagon socket wrench, to hold the rear shock absorber assembly in place, use a ball joint lock nut wrench to tighten the nut until the rear shock absorber cushion retainer is seated to the collar of the rear suspension support assembly.
Calculate the torque wrench reading when changing the fulcrum length of the torque wrench.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
When using a ball joint lock nut wrench (fulcrum length of 155.5 mm (6.12 in.)) + torque wrench (fulcrum length of 162 mm (6.38 in.))) : 7.7 N*m (79 kgf*cm, 68 in.*lbf))
for Double Nut Type:
Install a new nut (upper nut) onto the lower nut.
Hold the lower nut and tighten the upper nut against it.
64715C
5.INSTALL DECK SIDE TRIM COVER
Engage the 2 guides and 3 claws to install the deck side trim cover.
6.INSTALL REAR WHEEL
7. STABILIZE SUSPENSION
48540
8.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY
Fully tighten the rear shock absorber assembly (lower side) with the bolt while keeping the nut from rotating.
Because the nut has its own stopper, do not turn the nut. Tighten the bolt with the nut secured.
9.INSPECT REAR WHEEL ALIGNMENT