Home › Suspension › REAR SUSPENSION › REAR AXLE BEAM › 2020.03–2020.07
RM36W0E _53 Suspension _087264 REAR SUSPENSION _0417607 REAR AXLE BEAM A

REAR SUSPENSION  REAR AXLE BEAM  INSTALLATION  


PROCEDURE

Hide 42110F 1.TEMPORARILY TIGHTEN REAR AXLE BEAM ASSEMBLY

a.

Slowly jack up the rear axle beam assembly using an engine lifter, 2 wooden blocks and 2 plate lift attachments or equivalent tools and temporarily install the rear axle beam assembly to the vehicle with the 2 bolts.

C429098C02
6.344,1.719 5.813,1.625 true 1.281,1.667 0.719,1.792 true 2.99,1.573 3.625,1.271 3.625,1.271 4.135,1.573 true 2.958,3.125 3.625,2.198 true 0.448,1.698 0.688,1.927 0.24,0.229 10 true *b 3.521,1.073 3.771,1.25 0.25,0.177 10 true *a 2.781,3.063 3.094,3.219 0.313,0.156 10 false *c 6.375,1.635 6.594,1.854 0.219,0.219 10 true *b
*a Plate Lift Attachment *b Wooden Block
*c Engine Lifter - -


CAUTION:

Make sure to secure the rear axle beam assembly to prevent it from dropping.



b.

Temporarily install the rear axle beam assembly to the rear shock absorber assemblies LH and RH with the 2 bolts and 2 nuts.

NOTICE:

Because the nuts have their own stoppers, do not turn the nuts. Tighten the bolts with the nuts secured.



Hide 48231B 2.INSTALL REAR COIL SPRING LH

Hide 48231A 3.INSTALL REAR COIL SPRING RH

HINT:

Perform the same procedure as for the LH side.


Hide 42450B 4.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY LH

Hide 42450A 5.INSTALL REAR AXLE HUB AND BEARING ASSEMBLY RH

HINT:

Perform the same procedure as for the LH side.


Hide 6.INSTALL REAR WHEEL

Hide 7. STABILIZE SUSPENSION

a.

Lower the vehicle.


b.

Bounce the vehicle up and down several times to stabilize the suspension.


Hide 42110F 8.FULLY TIGHTEN REAR AXLE BEAM ASSEMBLY

a.

Fully tighten the 2 bolts.

Torque:
140 N*m (1428 kgf*cm, 103 ft.*lbf)


Hide 48540 9.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY LH

Hide 48760B 10.FULLY TIGHTEN REAR SHOCK ABSORBER ASSEMBLY RH

HINT:

Use the same procedure for the RH side as for the LH side.


Hide 11.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL (for HV Model)

Hide 15. INITIALIZATION AFTER RECONNECTING BATTERY TERMINAL (for HV Model)

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 16.PERFORM INITIALIZATION

Parking support brake system (Click here)
Parking assist monitor system (Click here)