Home › Vehicle Interior › METER / GAUGE / DISPLAY › HEADUP DISPLAY › 2020.03–2020.07
RM36W0E _58 Vehicle Interior _087985 METER / GAUGE / DISPLAY _0420199 HEADUP DISPLAY A

METER / GAUGE / DISPLAY  HEADUP DISPLAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during meter mirror sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative (-) auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

CAUTION:
B475753

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>PARKING ASSIST MONITOR SYSTEM>INITIALIZATION


HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Pre-collision system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 55302C 1.REMOVE INSTRUMENT PANEL SUB-ASSEMBLY

Hide 55084E 2.REMOVE NO. 1 HEATER TO REGISTER DUCT SUB-ASSEMBLY

Hide 83108 3.REMOVE METER MIRROR SUB-ASSEMBLY

a.
E438479

Disengage the clamp.


b.

Disconnect the connector.


c.
E438480

Remove the 2 nuts and bolt.


d.

Disengage the guide to remove the meter mirror sub-assembly.