Home › Power Source / Network › POWER DISTRIBUTION › INTEGRATION RELAY
RM36W0E _57 Power Source / Network _088265 POWER DISTRIBUTION _0420884 INTEGRATION RELAY A

POWER DISTRIBUTION  INTEGRATION RELAY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the semiconductor power integration ECU removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)

HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 1. PRECAUTION

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY


Hide 2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 82662A 3.REMOVE NO. 1 RELAY BLOCK COVER

a.
E438384

Disengage the claws to remove the No. 1 relay block cover.


Hide 82644 4.REMOVE SEMICONDUCTOR POWER INTEGRATION ECU

NOTICE:
·

Make sure the connector terminal is free from oil and grease.

·

Do not subject the semiconductor power integration ECU to any impact.

·

Do not use a semiconductor power integration ECU that has been dropped.

·

Do not disassemble the semiconductor power integration ECU.



a.
E438381

Disengage the claws and pull up the semiconductor power integration ECU.


b.
B578681C01
2.323,1.479 2.521,1.677 0.198,0.198 10 true *a
*a power source connector


Disconnect the power source connector.


c.

Disengage the claw and pull up the lock lever to disconnect the connector as shown in the illustration.