Home › Vehicle Interior › DOOR LOCK › FRONT DOOR LOCK › 2020.03–2020.07
RM36W0E _58 Vehicle Interior _088479 DOOR LOCK _0421642 FRONT DOOR LOCK A

DOOR LOCK  FRONT DOOR LOCK  INSTALLATION  


CAUTION / NOTICE / HINT

HINT:
·

Use the same procedure for the LH side and RH side.

·

The following procedure is for the RH side.



PROCEDURE

Hide 69750C 1.INSTALL FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY

B576090

a.

Engage the guide to install the front door inside locking cable assembly to the front door lock assembly.


Hide 69710B 2.INSTALL FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

a.
B576089

Engage the guide to install the front door lock remote control cable assembly to the front door lock assembly.


b.
B565998C02
0,0 0,0 false
V113147

Install in this Direction


Engage the claws as shown in the illustration.


Hide 69310 3.INSTALL FRONT DOOR LOCK ASSEMBLY

NOTICE:
·

When reusing a removed front door lock assembly, replace the door lock wiring harness seal with a new one.

·

Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

·

Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the front door lock assembly.



a.

Apply MP grease to the sliding parts of the front door lock assembly.


b.

When reusing the front door lock assembly:

i.
B576088

Install a new door lock wiring harness seal to the front door lock assembly.



c.
B565999

Connect the front door lock open rod as shown in the illustration.

HINT:

Make sure that the front door lock open rod is securely connected to the front door lock assembly.



d.

Using a T30 "TORX" socket wrench, install the front door lock assembly with the 3 screws.

Torque:
5.5 N*m (56 kgf*cm, 49 in.*lbf)


e.

Connect the connector.


Hide 69510 4.INSTALL FRONT DOOR LOCK CYLINDER ASSEMBLY (for Driver Side)

Hide 69210 5.INSTALL FRONT DOOR OUTSIDE HANDLE ASSEMBLY (for Driver Side)

Hide 67403F 6.INSTALL FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY

Hide 68141C 7.INSTALL FRONT DOOR GLASS RUN

Hide 68101 8.INSTALL FRONT DOOR GLASS SUB-ASSEMBLY

Hide 67831 9.INSTALL FRONT DOOR SERVICE HOLE COVER (for Driver Side)

Hide 67855B 10.INSTALL FRONT DOOR PANEL PROTECTOR

Hide 67837A 11.INSTALL FRONT DOOR VENT SEAL

Hide 68171B 12.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP

Hide 67601 13.INSTALL FRONT DOOR TRIM BOARD SUB-ASSEMBLY

Hide 67655 14.INSTALL FRONT DOOR TRIM GARNISH

Hide 74231 15.INSTALL POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Front Passenger Side)

Hide 74232 16.INSTALL MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY WITH FRONT ARMREST BASE UPPER PANEL (for Driver Side)

Hide 67491A 17.INSTALL FRONT DOOR LOWER FRAME BRACKET GARNISH

Hide 18.CONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL

Hide 19. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE

HINT:

When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.

Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART


Hide 20.INITIALIZE POWER WINDOW CONTROL SYSTEM