Home › Engine / Hybrid System › M15A-FXE (INTAKE / EXHAUST) › INTAKE MANIFOLD
RM36W0E _51 Engine / Hybrid System _088540 M15A-FXE INTAKE / EXHAUST _0421799 INTAKE MANIFOLD A

M15A-FXE INTAKE / EXHAUST  INTAKE MANIFOLD  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 1.INSTALL VACUUM HOSE

a.

Install the vacuum hose to the intake manifold.


Hide 17177 2.INSTALL NO. 1 INTAKE MANIFOLD TO HEAD GASKET

a.

Install a new No. 1 intake manifold to head gasket to the intake manifold.


Hide 17111 3.INSTALL INTAKE MANIFOLD

a.
A463764

Temporarily install the intake manifold and No. 2 fuel delivery guard to the cylinder head sub-assembly.


b.

Using an E8 "TORX" socket wrench, install the 2 stud bolts.

Torque:
6.5 N*m (66 kgf*cm, 58 in.*lbf)


c.
A463763E01
0.604,0.375 0.76,0.573 0.156,0.198 10 true 4 1.135,0.26 1.292,0.458 0.156,0.198 10 true 2 2.073,0.021 2.229,0.219 0.156,0.198 10 true 5 2.385,0.406 2.542,0.604 0.156,0.198 10 true 1 2.865,0.281 3.021,0.479 0.156,0.198 10 true 3

Temporarily install the 4 bolts and 2 nuts.


d.

Tighten the 4 bolts and 2 nuts in the order shown in the illustration.

Torque:
24 N*m (245 kgf*cm, 18 ft.*lbf)


Hide 82121 4.CONNECT ENGINE WIRE

a.
A463762

Engage the 3 clamps and connect the engine wire.


b.

Install the 3 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the connector.


Hide 89421 5.INSTALL E.F.I. VACUUM SENSOR ASSEMBLY (MANIFOLD ABSOLUTE PRESSURE SENSOR)

Hide 25601 6.INSTALL NO. 1 EGR PIPE SUB-ASSEMBLY

a.

Install a new EGR inlet gasket to the intake manifold.


b.

Install a new EGR valve adapter gasket to the No. 1 EGR pipe sub-assembly.


c.

Using an 8 mm socket wrench, install the No. 1 EGR pipe sub-assembly to the intake manifold and EGR valve assembly with the 4 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


d.

Engage the clamp to connect the engine wire.


e.

Connect the EGR valve assembly connector.


Hide 23826 7.CONNECT NO. 1 FUEL VAPOR FEED HOSE

a.

Connect the No. 1 fuel vapor feed hose to the intake manifold.


Hide 25860 8.INSTALL PURGE VALVE (PURGE VSV)

Hide 22030 9.INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY