The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during exhaust manifold removal/installation are shown below.
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
51447D
1.REMOVE CENTER NO. 4 ENGINE UNDER COVER
17410
2.REMOVE FRONT EXHAUST PIPE ASSEMBLY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.
Disconnect the No. 2 air fuel ratio sensor connector.
Disengage the clamp.
Remove the 4 bolts and 4 compression springs and disconnect the front exhaust pipe assembly from the exhaust manifold and tail exhaust pipe assembly.
Remove the front exhaust pipe assembly from the 3 exhaust pipe supports.
Remove the 2 exhaust pipe gaskets from the exhaust manifold and front exhaust pipe assembly.
58151
3.REMOVE NO. 1 FRONT FLOOR HEAT INSULATOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the nut and No. 1 front floor heat insulator from the vehicle body.
89467B
4.REMOVE AIR FUEL RATIO SENSOR
17167
5.REMOVE NO. 1 EXHAUST MANIFOLD HEAT INSULATOR
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 3 bolts and No. 1 exhaust manifold heat insulator from the exhaust manifold.
17118
6.REMOVE MANIFOLD STAY
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the bolt, nut and manifold stay from the exhaust manifold and cylinder block sub-assembly.
17141
7.REMOVE EXHAUST MANIFOLD
To prevent burns, do not touch the engine, exhaust manifold or other high temperature components while the engine is hot.
Remove the 6 nuts and exhaust manifold from the cylinder head sub-assembly.
Remove the exhaust manifold to head gasket from the cylinder head sub-assembly.
17168
8.REMOVE NO. 2 EXHAUST MANIFOLD HEAT INSULATOR
Remove the 3 bolts and No. 2 exhaust manifold heat insulator from the exhaust manifold.