Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › AIR FUEL RATIO SENSOR (for Sensor 1)
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422227 AIR FUEL RATIO SENSOR(for Sensor 1) A

M15A-FXE ENGINE CONTROL  AIR FUEL RATIO SENSOR(for Sensor 1)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the air fuel ratio sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of air fuel ratio sensor (sensor 1) Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Gas leak from exhaust system is repaired

CAUTION:
·
A344783

When the engine is hot, do not touch high-temperature areas such as the engine or exhaust manifold.

·

Touching high-temperature areas such as the engine and exhaust manifold could result in burns.



PROCEDURE

Hide 1.REMOVE WINDSHIELD WIPER MOTOR AND LINK

Hide 55735A 2.REMOVE WATER GUARD PLATE LH

Hide 55815E 3.REMOVE NO. 1 FRONT VENTILATOR SEAL

Hide 55701J 4.REMOVE OUTER COWL TOP PANEL SUB-ASSEMBLY

Hide 89467B 5.REMOVE AIR FUEL RATIO SENSOR

a.
A463030

Disconnect the air fuel ratio sensor connector.


b.

Disengage the 2 clamps.


c.
A463031N01
1.635,1.604 1.885,1.333 true 1.406,1.625 1.802,1.813 0.396,0.188 10 true SST

Using SST, remove the air fuel ratio sensor from the exhaust manifold.

SST
09224-00012  

NOTICE:

If the air fuel ratio sensor has been struck or dropped, replace it.