Use the same procedure for the RH and LH sides.
The procedure listed below is for the RH side.
8983A
1.INSTALL SIDE AIRBAG PRESSURE SENSOR
Check that the ignition switch is off.
Check that the cable is disconnected from the negative (-) auxiliary battery terminal.
Wait at least 90 seconds after disconnecting the cable from the negative (-) auxiliary battery terminal to disable the SRS system.
If the airbag deploys for any reason, it may cause a serious accident.
Engage the claw to hold the side airbag pressure sensor in place.
Install the side airbag pressure sensor with the nut.
If the side airbag pressure sensor has been dropped, replace it with a new one.
When installing the side airbag pressure sensor, be careful that the SRS wiring does not interfere with or is not pinched between other parts.
Check that there is no looseness in the installation parts of the side airbag pressure sensor.
Connect the airbag connector.
When connecting any airbag connector, take care not to damage the airbag wire harness.
Refer to How to Connect or Disconnect Airbag Connector: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM>HOW TO CONNECT OR DISCONNECT AIRBAG CONNECTOR
67831
2.INSTALL FRONT DOOR SERVICE HOLE COVER
68171B
3.INSTALL FRONT DOOR GLASS INNER WEATHERSTRIP
4.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
for Gasoline Model:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>INSTALLATION
for HV Model:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>INSTALLATION
5. INITIALIZATION AFTER RECONNECTING AUXILIARY BATTERY TERMINAL
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>WORK PROCEDURE
When disconnecting and reconnecting the auxiliary battery, there is an automatic learning function that completes learning when the respective system is used.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>AUTOMATIC LEARNING CHART
6. PERFORM DIAGNOSTIC SYSTEM CHECK
7.CHECK SRS WARNING LIGHT