Home › Drivetrain › P910 (HYBRID TRANSMISSION / TRANSAXLE) › HYBRID TRANSAXLE FLUID › 2020.03–2020.07
RM36W0E _52 Drivetrain _088636 P910 HYBRID TRANSMISSION / TRANSAXLE _0421990 HYBRID TRANSAXLE FLUID G

P910 HYBRID TRANSMISSION / TRANSAXLE  HYBRID TRANSAXLE FLUID  ON-VEHICLE INSPECTION  


PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide 2.INSPECT HYBRID TRANSAXLE FLUID

a.
C429455C03
3.156,1.719 3.417,1.938 0.26,0.219 10 false *a
*a 0 to 8 mm (0 to 0.315 in.)


Using a 10 mm hexagon socket wrench, remove the filler plug and gasket from the hybrid vehicle transaxle assembly.


b.

Check that the hybrid transaxle fluid level is between 0 to 8 mm (0 to 0.315 in.) from the bottom lip of the filler plug opening.

NOTICE:
·

When inspecting the hybrid transaxle fluid, make sure that the vehicle is level.

·

Be sure to directly check that the hybrid transaxle fluid level is within the specified range.

·

Driving the vehicle with an insufficient or excessive amount of hybrid transaxle fluid may damage the hybrid vehicle transaxle assembly.

·

If the hybrid transaxle fluid was replaced or if hybrid transaxle fluid was added, make sure to recheck the hybrid transaxle fluid level after driving the vehicle.




c.

Check for leaks if the hybrid transaxle fluid level is low. (If there are no hybrid transaxle fluid leaks but the hybrid transaxle fluid level is low, add hybrid transaxle fluid.)

Click hereDrivetrain>P910 (HYBRID TRANSMISSION / TRANSAXLE)>HYBRID TRANSAXLE FLUID>ADJUSTMENT


d.

Using a 10 mm hexagon socket wrench, install the filler plug and a new gasket to the hybrid vehicle transaxle assembly.

Torque:
50 N*m (510 kgf*cm, 37 ft.*lbf)


Hide 3.INSPECT FOR HYBRID TRANSAXLE FLUID LEAK

Hide 51451A 4.INSTALL CENTER ENGINE UNDER COVER