The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the transaxle side cover sub-assembly removal/installation are shown below.
51451A
1.REMOVE CENTER ENGINE UNDER COVER
51442C
2.REMOVE ENGINE UNDER COVER LH
3.DRAIN CONTINUOUSLY VARIABLE TRANSAXLE FLUID
Remove the refill plug and gasket from the rear transaxle case sub-assembly.
Using a 10 mm hexagon socket wrench, remove the overflow plug and gasket from the transaxle case sub-assembly.
| *1 | Overflow (CVT) Tube |
Using a 6 mm hexagon socket wrench, remove the overflow (CVT) tube from the transaxle case sub-assembly.
Removing the overflow (CVT) tube will drain all oil in the transaxle case sub-assembly.
Using a 6 mm hexagon socket wrench, install the overflow (CVT) tube to the transaxle case sub-assembly.
Using a 10 mm hexagon socket wrench, temporarily install the overflow plug and gasket to the transaxle case sub-assembly.
Reuse the old gasket as the overflow plug will be removed again to adjust the fluid level.
Temporarily install the gasket and refill plug to the rear transaxle case sub-assembly.
Reuse the old gasket as the refill plug will be removed again to adjust the fluid level.
17705
4.REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE
17701
5.REMOVE AIR CLEANER CASE SUB-ASSEMBLY
82121
6.REMOVE ENGINE WIRE
Disengage the 2 clamps to disconnect the engine wire from the continuously variable transaxle assembly.
7.INSTALL WIRE HARNESS CLAMP BRACKET
Remove the bolt and the wire harness clamp bracket from the continuously variable transaxle assembly.
35015Y
8.REMOVE TRANSAXLE SIDE COVER SUB-ASSEMBLY
Remove the 11 bolts and transaxle side cover sub-assembly from the transaxle case sub-assembly.
Remove the O-ring from the transaxle side cover sub-assembly.