This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
23250
1.INSTALL FUEL INJECTOR ASSEMBLY
Perform "Inspection After Repair" after replacing a fuel injector assembly.
Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
Apply a light coat of spindle oil or gasoline to 3 new O-rings, and install one to each fuel injector assembly.
Check that there is no damage or foreign matter on the groove of the fuel injector assembly when installing the O-ring to each fuel injector assembly.
| *a | Stopper |
| *b | Claw |
Install the 3 fuel injector assemblies to the fuel delivery pipe.
Make sure that the fuel injector assembly is located within the stopper as shown in the illustration.
Check that the fuel injector assembly installation holes of the fuel delivery pipe are not damaged and are free of foreign matter.
Make sure that the O-ring is not damaged, twisted or moved out of place when installing the fuel injector assembly.
82125N
2.INSTALL NO. 5 ENGINE WIRE
Engage the 2 clamps to install the No. 5 engine wire to the fuel delivery pipe.
Connect the 4 connectors to the 3 fuel injector assemblies and fuel pressure sensor.
23291
3.INSTALL INJECTOR VIBRATION INSULATOR
Install 3 new injector vibration insulators to the cylinder head sub-assembly.
23891
4.INSTALL FUEL DELIVERY SPACER
Install the 2 fuel delivery spacers to the cylinder head sub-assembly.
23814B
5.INSTALL FUEL DELIVERY PIPE
Place the fuel delivery pipe with the 3 fuel injector assemblies onto the cylinder head sub-assembly.
Be careful not to drop the fuel injector assemblies when installing the fuel delivery pipe.
Install the fuel delivery pipe with the fuel injector assemblies with the 2 bolts.
23902
6.CONNECT FUEL TUBE SUB-ASSEMBLY
Connect the fuel tube sub-assembly to the fuel delivery pipe.
Click hereEngine / Hybrid System>M15A-FXE (FUEL)>FUEL SYSTEM>PRECAUTION
25624
7.INSTALL EGR VALVE ADAPTER
Engage the guide to Install the EGR valve adapter.
Using an 8 mm socket wrench, install the bolt.
8.INSTALL EGR VALVE WITH COOLER ASSEMBLY
9.INSTALL INTAKE MANIFOLD
10.INSPECT FOR FUEL LEAK
11.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing a fuel injector assembly.
Click hereEngine / Hybrid System>M15A-FXE (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION