Home › Engine / Hybrid System › M15A-FKS (ENGINE CONTROL) › CAMSHAFT OIL CONTROL VALVE (for Intake Side)
RM36W0E _51 Engine / Hybrid System _087499 M15A-FKS ENGINE CONTROL _0422193 CAMSHAFT OIL CONTROL VALVE(for Intake Side) A

M15A-FKS ENGINE CONTROL  CAMSHAFT OIL CONTROL VALVE(for Intake Side)  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the intake camshaft timing gear bolt assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
Replacement of camshaft timing gear assembly Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 51441C 1.REMOVE ENGINE UNDER COVER RH

Hide 15370 2.REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY (for Intake Side)

Hide 3.SET NO. 1 CYLINDER TO TDC/COMPRESSION

a.
A463047C01
2.156,1.688 1.76,1.125 true 1.948,0.563 1.615,0.563 true 1.979,0.458 2.167,0.646 0.188,0.188 10 true *b 2.188,1.604 2.385,1.781 0.198,0.177 10 true *a
*a Timing Mark (Cutout)
*b Protrusion


Turn the crankshaft pulley clockwise until its timing mark (cutout) is aligned with the protrusion on the timing chain cover assembly as shown in the illustration.


b.
A463048C01
1.479,4.375 1.719,4.042 true 1.458,0.385 1.719,0.646 true 0.083,0.156 0.323,0.354 0.24,0.198 10 true *a 0.094,2.51 0.365,2.74 0.271,0.229 10 true *b 1.26,0.281 1.438,0.469 0.177,0.188 10 true *c 2.875,0.167 3.094,0.375 0.219,0.208 10 true *d 2.885,2.521 3.104,2.729 0.219,0.208 10 true *d 1.302,4.313 1.479,4.51 0.177,0.198 10 true *c
*a Correct
*b Incorrect
*c Cutout
*d Up


Check that the cutout of the camshaft timing gear assembly is at the top.

HINT:

If the cutout of the camshaft timing gear assembly is not at the top, turn the crankshaft 360° clockwise and align the timing mark (cutout) of the crankshaft pulley with the protrusion on the timing chain cover assembly again.



Hide 135A0 4.REMOVE CAMSHAFT TIMING GEAR BOLT

a.
A463049

While holding the crankshaft pulley, remove the camshaft timing gear bolt.

NOTICE:
·

If the camshaft timing gear bolt has been struck or dropped, replace it.

·

Do not turn the crankshaft pulley after removing the camshaft timing gear bolt.