Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › THROTTLE BODY
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422219 THROTTLE BODY A

M15A-FXE ENGINE CONTROL  THROTTLE BODY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the throttle body with motor assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedure Effect/Inoperative when not Performed Link
·

Replacement of throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide 17881 3.REMOVE NO. 1 AIR CLEANER HOSE

a.
A463034C01
0.594,1.76 0.771,1.625 true 0.896,0.427 1.333,0.177 true 1.552,0.667 1.948,0.531 true 1.333,0.073 1.573,0.292 0.24,0.219 10 true *b 0.344,1.656 0.583,1.875 0.24,0.219 10 true *c 1.958,0.417 2.198,0.635 0.24,0.219 10 true *a
*a No. 2 Ventilation Hose
*b Hose Clip
*c Hose Clamp


Slide the hose clip to disconnect the No. 2 ventilation hose from the cylinder head cover sub-assembly.


b.

Loosen the 2 hose clamps to remove the No. 1 air cleaner hose from the throttle body with motor assembly.


Hide 22030 4.REMOVE THROTTLE BODY WITH MOTOR ASSEMBLY

a.
A463035

Slide the clip and disconnect the No. 8 water by-pass hose from the throttle body with motor assembly.


b.

Slide the clip and disconnect the No. 5 water by-pass hose to remove the throttle body with motor assembly.


c.
A463101

Disconnect the throttle body with motor assembly connector.


d.

Using an 8 mm socket wrench, remove the 3 bolts to separate the throttle body with motor assembly from the intake manifold.

NOTICE:

If the throttle body with motor assembly has been struck or dropped, replace it.



Hide 22271 5.REMOVE THROTTLE BODY GASKET

a.
A463100

Remove the throttle body gasket from the intake manifold.