Home › Engine / Hybrid System › M15A-FXE (ENGINE CONTROL) › ENGINE COOLANT TEMPERATURE SENSOR › 2020.03–2020.07
RM36W0E _51 Engine / Hybrid System _087500 M15A-FXE ENGINE CONTROL _0422225 ENGINE COOLANT TEMPERATURE SENSOR A

M15A-FXE ENGINE CONTROL  ENGINE COOLANT TEMPERATURE SENSOR  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during engine coolant temperature sensor removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
Replacement of engine coolant temperature sensor Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

HINT:

When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 51451A 1.REMOVE CENTER ENGINE UNDER COVER

Hide G9200 3.REMOVE INVERTER WITH CONVERTER ASSEMBLY

Hide 89422A 4.REMOVE ENGINE COOLANT TEMPERATURE SENSOR

a.
A463114

Disconnect the engine coolant temperature sensor connector.


b.
A463115

Remove the clip and engine coolant temperature sensor from the water outlet.

NOTICE:

If the engine coolant temperature sensor has been struck or dropped, replace it.