Home › Engine / Hybrid System › M15A-FXE (LUBRICATION) › OIL PUMP
RM36W0E _51 Engine / Hybrid System _088718 M15A-FXE LUBRICATION _0422245 OIL PUMP A

M15A-FXE LUBRICATION  OIL PUMP  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during engine unit removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Throttle body with motor assembly

·

Cleaning the deposits from the throttle body with motor assembly

·

Cam timing control motor with EDU assembly

·

Removal and installation of a cam timing control motor with EDU assembly

·

Engine assembly

·

Mass air flow meter sub-assembly

·

Air fuel ratio sensor (sensor 1)

·

Air fuel ratio sensor (sensor 2)

·

Ignition coil assembly

·

EGR valve assembly

·

Air leaks from intake system

·

Gas leaks from exhaust system

·

Knock control sensor


Inspection after repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

PROCEDURE

Hide 12262 3.REMOVE NO. 2 VENTILATION HOSE

Hide 15370 5.REMOVE CAM TIMING OIL CONTROL SOLENOID ASSEMBLY

Hide 13090D 7.REMOVE CAM TIMING CONTROL MOTOR WITH EDU ASSEMBLY

Hide 13470 9.REMOVE CRANKSHAFT PULLEY ASSEMBLY

Hide 11201 10.REMOVE CYLINDER HEAD COVER SUB-ASSEMBLY

Hide 11193 11.REMOVE SPARK PLUG TUBE GASKET

Hide 12315A 12.REMOVE ENGINE MOUNTING BRACKET RH

Hide 13.REMOVE STRAIGHT SCREW PLUG

a.
A463138

Using a 10 mm hexagon wrench, remove the straight screw plug from the No. 2 timing chain cover assembly.


Hide 11320B 14.REMOVE NO. 2 TIMING CHAIN COVER ASSEMBLY

a.
A463139

Remove the 17 bolts.


b.

Remove the No. 2 timing chain cover assembly from the timing chain cover assembly by prying the No. 2 timing chain cover assembly with a screwdriver with its tip wrapped with protective tape.

A463140


c.
A463732

Remove the oil pump gasket from the cylinder block sub-assembly.

NOTICE:

Be careful not to damage the contact surfaces of the No. 2 timing chain cover assembly and timing chain cover assembly.



Hide 11301C 15.REMOVE TIMING GEAR CASE OR TIMING CHAIN CASE OIL SEAL