88460
1.INSTALL COOLER CONDENSER ASSEMBLY
|
Install in this Direction (1) |
|
Install in this Direction (2) |
Engage the guides and claws to install the cooler condenser assembly as shown in the illustration.
Do not damage the cooler condenser assembly or radiator assembly when installing the cooler condenser assembly.
If a new cooler condenser assembly is installed, add compressor oil to the cooler condenser assembly as follows.
Add 40 cc (1.35 fl. oz)
or Gasoline Model:
ND-OIL 8 or equivalent
for HV Model:
ND-OIL 11 or equivalent
88716A
2.INSTALL COOLER REFRIGERANT LIQUID PIPE A
Remove the vinyl tape from the cooler refrigerant liquid pipe A and cooler condenser assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler refrigerant liquid pipe A.
for Gasoline Model:
ND-OIL 8 or equivalent
for HV Model:
ND-OIL 11 or equivalent
Install the O-ring to the cooler refrigerant liquid pipe A.
Keep the O-rings and O-ring fitting surfaces free from foreign matter.
Connect the cooler refrigerant liquid pipe A to the cooler condenser assembly with the bolt.
88703
3.INSTALL DISCHARGE HOSE SUB-ASSEMBLY
Remove the vinyl tape from the discharge hose sub-assembly and cooler condenser assembly.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the discharge hose sub-assembly.
for Gasoline Model:
ND-OIL 8 or equivalent
for HV Model:
ND-OIL 11 or equivalent
Install the O-ring to the discharge hose sub-assembly.
Keep the O-rings and O-ring fitting surfaces free from foreign matter.
Connect the discharge hose sub-assembly to the cooler condenser assembly with the bolt.
53036C
4.INSTALL FRONT END PANEL MOUNTING BRACKET SUB-ASSEMBLY LH
Engage the guides to install the front end panel mounting bracket sub-assembly LH.
Install the bolt.
53035C
5.INSTALL FRONT END PANEL MOUNTING BRACKET SUB-ASSEMBLY RH
Engage the guides to install the front end panel mounting bracket sub-assembly RH.
16595D
6.INSTALL NO. 1 RADIATOR AIR GUIDE LH
16561D
7.INSTALL NO. 1 RADIATOR TO SUPPORT SEAL
16562L
8.INSTALL NO. 2 RADIATOR TO SUPPORT SEAL
16681A
9.INSTALL RADIATOR UPPER AIR GUIDE PLATE
52131A
10.INSTALL FRONT BUMPER REINFORCEMENT
52611
11.INSTALL FRONT BUMPER ENERGY ABSORBER
53510
12.INSTALL HOOD LOCK ASSEMBLY
86520
13.INSTALL LOW PITCHED HORN ASSEMBLY
Click hereVehicle Exterior>HORN>HORN>INSTALLATION
14.CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT
15. WARM UP ENGINE (for Gasoline Model)
16.WARM UP COMPRESSOR (for HV Model)
17.INSPECT FOR REFRIGERANT LEAK