The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during No.1 clearance warning buzzer removal/installation are shown below.
When the cable is disconnected/reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After the ignition switch is turned off, there may be a waiting time before disconnecting the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
2.DISCONNECT CABLE FROM NEGATIVE AUXILIARY BATTERY TERMINAL
for M15A-FKS:
Click hereGeneral>MAINTENANCE>M15A-FKS AUXILIARY BATTERY>REMOVAL
for M15A-FXE:
Click hereGeneral>MAINTENANCE>M15A-FXE AUXILIARY BATTERY>REMOVAL
55480D
3.REMOVE INSTRUMENT PANEL FINISH PANEL ASSEMBLY LWR
4.REMOVE INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY RH
Remove the 2 nuts.
Disconnect the each connector.
Disengage the clamps to remove the instrument panel junction block assembly RH.
89343C
5.REMOVE NO. 1 CLEARANCE WARNING BUZZER
Disengage the clamp to remove the No.1 clearance warning buzzer.