Home › Engine / Hybrid System › HYBRID / BATTERY CONTROL › BATTERY ECU
RM36W0E _51 Engine / Hybrid System _087936 HYBRID / BATTERY CONTROL _0424584 BATTERY ECU A

HYBRID / BATTERY CONTROL  BATTERY ECU  INSTALLATION  


PROCEDURE

Hide 89890A 1.INSTALL BATTERY ECU ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the battery ECU assembly to the HV battery with the 3 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)

NOTICE:
·

The type of battery ECU assembly to be used varies depending on the vehicle model.

·

If the wrong type of battery ECU assembly is installed, the ignition switch cannot be turned on (READY).

·

If the battery ECU assembly has been struck or dropped, replace it.




b.

Connect the 3 battery ECU assembly connectors.

NOTICE:

Make sure that the connectors are connected securely.



Hide G929A 2.INSTALL NO. 1 HV BATTERY HOSE

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the No. 1 HV battery hose to the HV battery with the clip.


Hide G920NB 3.INSTALL UPPER HV BATTERY COVER SUB-ASSEMBLY

CAUTION:

Be sure to wear insulated gloves and protective goggles.


a.

Install the upper HV battery cover sub-assembly to the HV battery with the 4 bolts and 6 nuts.

Torque:
7.5 N*m (76 kgf*cm, 66 in.*lbf)


Hide 821H1 5.CONNECT HV FLOOR UNDER WIRE

Hide G929A 6.INSTALL NO.1 HV BATTERY HOSE

Hide G92N1 7.INSTALL HV BATTERY UPPER COVER PANEL

Hide 71033 8.INSTALL REAR SEAT CUSHION LEG SUB-ASSEMBLY

Hide 72693 10.INSTALL REAR SEAT CUSHION LOCK HOOK

Hide 11.INSTALL BENCH TYPE REAR SEAT CUSHION ASSEMBLY

Hide 73350C 12.CONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

Hide 14. CURRENT SENSOR OFFSET LEARNING

HINT:

Perform this procedure when the HV battery junction block assembly or battery ECU assembly has been replaced.

Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HV RELAY ASSEMBLY>INSTALLATION