The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during HV floor under wire removal/installation are shown below.
Orange wire harnesses and connectors indicate high-voltage circuits. To prevent electric shock, always follow the procedure described in the repair manual.
Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM>PRECAUTION
To prevent electric shock, wear insulated gloves when working on wire harnesses and components of the high voltage system.
When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.
Learning completes when vehicle is operated normally
1. PRECAUTION
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) auxiliary battery terminal.
Click hereGeneral>SETUP>WHEN DISCONNECTING OR RECONNECTING BATTERY TERMINAL>BEFORE DISCONNECTING BATTERY
G3834
2.REMOVE SERVICE PLUG GRIP
82121
3.DISCONNECT ENGINE WIRE
4.REMOVE CONNECTOR COVER ASSEMBLY
5.CHECK TERMINAL VOLTAGE
6.TEMPORARILY INSTALL CONNECTOR COVER ASSEMBLY
821H1
7.DISCONNECT FLOOR UNDER WIRE
73350C
8.DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY
9.REMOVE BENCH TYPE REAR SEAT CUSHION ASSEMBLY
72693
10.REMOVE REAR SEAT CUSHION LOCK HOOK
76971G
11.REMOVE REAR UNDER COVER
71033
12.REMOVE REAR SEAT CUSHION LEG SUB-ASSEMBLY
G9230
13.REMOVE BATTERY COOLING BLOWER ASSEMBLY
G92N1
14.REMOVE HV BATTERY UPPER COVER PANEL
821H1
15.DISCONNECT FLOOR UNDER WIRE
Wear insulated gloves.
| *a | Shield Ground |
Disconnect the 2 HV battery junction block assembly connectors.
Insulate each disconnected high-voltage connector with insulating tape. Wrap the connector from the wire harness side to the end of the connector.
Disconnect the shield ground from the HV battery.
Disconnect the floor wire connector.
57628E
16.REMOVE REAR FLOOR SIDE MEMBER COVER LH
Remove the 2 bolts.
Disengage the grommet to remove the rear floor side member cover LH.
64740C
17.REMOVE FRONT FLOOR COVER LH
Remove the 2 bolts, 2 clips and disengage the 6 clamps to remove the front floor cover LH from the vehicle body.
51201
18.REMOVE FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY
821H1
19.REMOVE FLOOR UNDER WIRE
Wear insulated gloves.
Insulate the disconnected connectors with insulating tape.
Remove the 2 nuts.
Remove the 3 nuts and clamp.
If the clamps are removed forcibly, the stud bolts may be damaged.
Disengage the grommet and pull out the HV floor under wire from the floor panel hole.
Disengage the 4 clamps.
Disconnect the HV floor under wire connector.
Remove the bolt, nut and HV floor under wire.