Home › Engine / Hybrid System › M15A-FKS (ENGINE MECHANICAL) › CAMSHAFT › 2020.03–2020.07
RM36W0E _51 Engine / Hybrid System _087837 M15A-FKS ENGINE MECHANICAL _0424625 CAMSHAFT A

M15A-FKS ENGINE MECHANICAL  CAMSHAFT  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during camshaft removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative auxiliary battery terminal Memorize steering angle neutral point Parking assist monitor system (Click here)
·

Air leaks from intake system is repaired

·

Gas leaks from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)
Replacement of CVT fluid ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly (Click here)
Front wheel alignment adjustment Calibration
·

VSC disabled or malfunctions

·

DTCs are stored

·

Slip indicator light illuminates

·

ABS warning light illuminates


(Click here)

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


HINT:

When the cable is disconnected / reconnected to the auxiliary battery terminal, systems temporarily stop operating. However, each system has a function that completes learning the first time the system is used.

·

Learning completes when vehicle is driven

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Lane tracing assist system Drive the vehicle straight ahead at 35 km/h (22 mph) or more for 5 second or more. (Click here)
Pre-collision system

·

Learning completes when vehicle is operated normally

Effect/Inoperative Function When Necessary Procedures are not Performed Necessary Procedures Link
Power door lock control system
·

Back door opener


Perform door unlock operation with door control switch or electrical key transmitter sub-assembly switch. (Click here)
Air conditioning system After the ignition switch is turned to ON, the servo motor standard position is recognized. -



PROCEDURE

Hide 11320B 1.REMOVE NO. 2 TIMING CHAIN COVER ASSEMBLY

Hide 3.SET NO. 1 CYLINDER TO TDC (COMPRESSION)

Hide 13050 4.REMOVE CAMSHAFT TIMING GEAR ASSEMBLY

Hide 13540 6.REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY

Hide 13559 7.REMOVE CHAIN TENSIONER SLIPPER

Hide 13561 8.REMOVE NO. 1 CHAIN VIBRATION DAMPER

Hide 13070A 9.REMOVE CAMSHAFT TIMING EXHAUST GEAR ASSEMBLY

Hide 11310 10.REMOVE TIMING CHAIN COVER ASSEMBLY

Hide 13631 11.REMOVE BALANCESHAFT DRIVE GEAR

Hide 23477 12.REMOVE FUEL PUMP LIFTER GUIDE

Hide 11103 13.REMOVE CAMSHAFT HOUSING SUB-ASSEMBLY

Hide 13501A 15.REMOVE INTAKE CAMSHAFT SUB-ASSEMBLY

Hide 13502B 16.REMOVE EXHAUST CAMSHAFT SUB-ASSEMBLY